Servicios Personalizados
Revista
Articulo
Indicadores
- Citado por SciELO
- Accesos
Links relacionados
- Similares en SciELO
Compartir
Revista mexicana de física E
versión impresa ISSN 1870-3542
Rev. mex. fís. E vol.54 no.1 México jun. 2008
Enseñanza
Thermal model for a microhot plate used in a MEM gas sensor
M. Alfredo ReyesBarrancaª, J.L. GonzálezVidalb, and A. TaviraFuentesª
ª Department of Electrical Engineering, CINVESTAVIPN, MÉXICO, D.F., México.
b C.I.T.I.S., Universidad Autónoma del Estado de Hidalgo, Carretera PachucaTulancingo Km. 4.5, Pachuca Hidalgo, México 42076. email: mreyes@cinvestav.mx
Recibido el 3 de mayo de 2007
Aceptado el 28 de junio de 2007
Abstract
A thermal analytical model for a MEM gas sensor is presented and compared with an electrical circuit equivalent model. The objective is to study the temperature performance of the microhot plate configured within a MEM structure used for gas sensing. From this, it is possible to determine the magnitude of the electrical current that must be applied to the polysilicon heater on regard of its dimensions and materials used, for instance, when the sensor structure is fabricated with a MEMS technology compatible with CMOS integrated circuits fabrication. Results are presented where the response time and temperature level, as a function of applied current, can be determined. The model presented can be used as a base for designing microhot plates operating in gas sensors, where temperatures in the order of 300° C are needed and that will be integrated monolithically with associated electronics, with constraints as minimum power dissipation.
Keywords: MEMS; microhot plate; thermal conductivity; electrothermal response.
Resumen
En este trabajo se presenta un modelo analítico térmico para un microsensor de gas MEM y, además se compara con un modelo de circuito eléctrico equivalente, con el objetivo de estudiar el comportamiento térmico de una micro placa caliente de una estructura MEM utilizada en el sensado de gases. Por lo anterior, es posible determinar la magnitud de la corriente eléctrica que debe ser aplicada a un micro calefactor de polisilicio, considerando sus dimensiones y los materiales utilizados; por ejemplo, cuando la estructura del sensor es fabricada con tecnología MEMS, la cual es compatible con la fabricación de circuitos integrados CMOS. Los resultados mostrados son el tiempo de respuesta y nivel de temperatura como función de la temperatura corriente aplicada. El modelo presentado puede ser aplicado como base para el diseño de micro placas calientes usadas en sensores de gases, donde se necesitan temperaturas en el orden de los 300°C, dichos sensores de gas seran integrados monolíticamente con su electrónica asociada correspondiente, considerando un consumo de potencia mínima.
Descriptores: MEMS; microplaca caliente; conductividad térmica; respuesta electrotérmica.
PACS: 82.47.Rs; 82.45.Mp; 85.40e
DESCARGAR ARTÍCULO EN FORMATO PDF
References
1. S.J. Pearton, D.P. Norton, K. Ip and Y.W. Heo, J. Vac. Sci. Technol. B 22 (2004) 932. [ Links ]
2. J. Brezmes et al., IEEE Sensors Journal 5 (2005) 97. [ Links ]
3. J. S. Suehle, M. Gaitan, and S. Semancik, IEEE Electron Device Letters 14 (1993) 118. [ Links ]
4. D. Vincenzi et al., J. Vac. Sci. Technol. B 18 (2000) 2441. [ Links ]
5. M. Y. Agridi et al., IEEE Sensors Journal 2 (2002) 644. [ Links ]
6. M. Graf et al., IEEE Sensors Journal 4 (2004) 9. [ Links ]
7. D. Barrentino et al., Proceedings IEEE Int. Symp. on Circ. and Syst., ISCAS 2:157 (2002) II157. [ Links ]
8. J. Laconte, C. Dupont, D. Flandre, and J.P. Raskin, IEEE Sensors Journal 4 (2004) 670. [ Links ]
9. D. Barrentino et al., IEEE Journal of SolidState Circuits 39 (2004) 1202. [ Links ]
10. J.C. Belmonte et al., Sensors and Actuators B 114 (2006) 881. [ Links ]
11. O. Brand and G.K. Fedder, Advanced Micro & Nanosystems Ed. WileyVCH (2005). [ Links ]
12. Y. Amemiya, T. Ono, and K. Kato, IEEE Trans. Electron Devices ED26 (1979) 1738. [ Links ]
13. C.H. Mastrengelo, J.H. Yeh, and R.S. Muller, IEEE Trans. Electron Devices 39 (1992) 1363. [ Links ]
14. TaiRan Hsu, MEMS & Microsystems. Design and Manufacture McGraw Hill (2002). [ Links ]
15. M. Necati Osizik, Boundary Value Problems of Heat Conduction Dover Publications, Inc, Minoela, (New York 1968) 262. [ Links ]
16. P.E. Allen and D.R. Douglas, CMOS Analog Circuit Design Saunders College Publishing (1987). [ Links ]
17. W. Gardner Julian, Microsensors, MEMS and Smart Devices John Wiley and Sons (2001). [ Links ]
18. J.L. Gonzalez Vidal, A. Reyes Barranca, M de la L. Olvera, A. Maldonado, and W. Calleja Arriaga, Smart Sensors and Actuators, and MEMS II, Proc. of SPIE 5836 (2005) 247. [ Links ]
19. JrHung Tsai and Liwei Lin, Journal of Heat Transfer 124 (2002) 375. [ Links ]